Moffat MUL 514 - Manual (Page 14)

14
Positioning
The appliance should only be installed at a
location where the ambient temperature
corresponds to the climate classification
indicated on the rating plate, which is located
on the inside right of the appliance.
The following table shows which ambient
temperature is correct for each climate
classification:
SN +10°C to + 32°C
N +16°C to + 32°C
ST +18°C to + 38°C
T
+18°C to + 43°C
The appliance should be located in a dry
atmosphere, out of direct sunlight and away
from continuous heat and extreme
temperature, e.g. not next to a boiler or radiator
or in a very cold room e.g. an outhouse. If
these temperatures are exceeded i.e. warmer
or colder, then the appliance may not operate
correctly.
For building-in and door reversal instructions
please refer to the relevant instructions on the
following pages.
1
2
3
4
5
6
6
1
6
8
7
2
10
11
9
12
13
6
6
3
Attention
After completion of the door reversing
operation, check that the door gasket
adheres to the cabinet. If the ambient
temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In
that case, wait for the natural fitting of the
gasket or accelerate this process by heating
up the part involved with a normal hairdryer
on a low setting.
Door Reversal
To reverse the opening direction of the door,
proceed as shown in the figures:
2222685-50.qxd 14/04/2006 13.47 Pagina 14