beautypg.com

Operation, Installing or removing socket, Socket 2. anvil 1 2 – Makita 6911HD User Manual

Page 10

background image

10

Installing or removing socket

To install the socket, push it onto the anvil of the tool until it
locks into place.
To remove the socket, simply pull it off.

OPERATION

The proper fastening torque may differ depending upon the
kind or size of the bolt, the material of the workpiece to be
fastened, etc. The relation between fastening torque and fas-
tening time is shown in the figures.

Hold the tool firmly and place the socket over the bolt or nut.
Turn the tool on and fasten for the proper fastening time.

NOTE:

When fastening screw M8 (5/16”) or smaller, carefully
adjust pressure on the switch trigger so that the screw is
not damaged.

Hold the tool pointed straight at the bolt or nut.

Excessive fastening torque may damage the bolt/nut or
socket. Before starting your job, always perform a test
operation to determine the proper fastening time for your
bolt or nut. Especially for the bolt smaller than M8 (5/
16”), perform the above test operation to prevent the
trouble on socket or bolt, etc.

If the tool is operated continuously until the battery
cartridge has discharged, allow the tool to rest for 15
minutes before proceeding with a fresh battery.

The fastening torque is affected by a wide variety of factors
including the following. After fastening, always check the
torque with a torque wrench.

1. When the battery cartridge is discharged almost com-

pletely, voltage will drop and the fastening torque will be
reduced.

2. Socket

Failure to use the correct size socket will cause a
reduction in the fastening torque.

1. Socket

2. Anvil

1

2

002341

002357

N.m (ft.lbs)

80
(58)

100
(72)

60
(43)

40
(29)

20
(14)

0

1

2

3

4

5

6

(S)

M14 (9/16”)

M12 (1/2”)

M10 (3/8”)

M10

M12

M14

Standard bolt

N.m (ft.lbs)

80
(58)

100
(72)

120
(87)

60
(43)

40
(29)

20
(14)

0

1

2

3

4

5

6

(S)

M8 (5/16”)

M12 (1/2”)

M10 (3/8”)

M10

M12

M8

High tensile bolt

002358