Mercedes-Benz SL 600 - Manual (Page 143)

142
Controls in detail
Control system
Lighting submenu
Access the Lighting submenu via the
Settings menu. Use the Lighting sub-
menu to change the lamp and lighting set-
tings on your vehicle. The following
functions are available:
Setting daytime running lamp mode
(USA only)
̈ Move the selection marker with button
æ or ç to the
Lighting sub-
menu.
̈ Press button j or k repeatedly
until you see this message in the left
display:
Light circuit Headlamp
mode .
The selection marker is on the current
setting.
̈ Press æ or ç to select manual or
daytime running lamp (constant) mode.
This function is not available in coun-
tries where daytime running lamps are
mandatory.
With daytime running lamp mode se-
lected and the exterior lamp switch at
position
M, the following lamps will
come on automatically when the en-
gine is turned on:
ț Parking lamps and low beam head-
lamps
ț License plate lamps
Function Page
Set daytime running lamp mode
(USA only) 142
Set locator lighting 143
Exterior lamps delayed
switch-off 143
Interior lighting delayed
switch-off 145
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
Lighting submenu to factory settings
( ୴ page 111) will not reset the daytime
running lamp mode.
In the right display you will then see the
message:
Cannot be fully reset to
factory settings while driv.! .