Monitor Audio BX Series - Manual (Page 10)

Bronze BX 8
Plinth FiXing
(BX5 & BX6 only)
The Bronze BX5 & BX6’s are provided with plinths to improve stability and acoustic response.
The plinths are secured in place by using the supplied bolts.
Before you fit the plinth ensure the floor area is clear of any hard/sharp objects. To fit the
plinth turn the cabinet over so that the bottom is facing upwards. Then, place the plinth
onto the cabinet ensuring the plinth is orientated correctly, lining up the bolt holes in the
plinth with the inserts in the cabinet. Using the bolts, secure the plinth to the cabinet.
Tighten them up gradually at first and ensure the plinth is fitted securely to the cabinet. Fit
the feet to the plinth before turning the loudspeaker back over. (Please read the instructions
opposite). The spikes are used to improve sound quality and bass performance
sPikes and Feet
The floorstanders from the Bronze BX Series come with spikes and separate rubber feet.
The spikes are to be used on carpeted floors and the rubber feet for use on hard floors
where spikes are not appropriate.
The spikes screw into the threaded inserts on the underside of the plinth. If you do not wish
to use the plinth, spikes can be fixed directly into the bottom of the cabinet. Ensure there
are no trailing cables where the speakers will be sited.
NOTE: When used without the plinth the stability of the cabinet will be reduced
because the cabinet footprint will be reduced.
When used on hard floor, the rubber feet simply push into the same inserts that would
usually be occupied by the spikes.
Bronze BX Manual.indd 8 10/03/2010 10:55:34