Philips Magnavox mrd120 - Manual (Page 18)

18
8239 300 30533
Step 3: Setting the speakers
You can adjust the delay time (center and
rear speakers only) and volume level for
individual speakers. These adjustments let
you optimize the sound according to
your surroundings and setup.
Test Tone - Turning on/off
If you have turned on the test tone, the
test signal will be automatically generated
to help you judge the sound level of each
speaker.
1
In disc mode, press SYSTEM MENU.
➜ Use the 1 2 3 4 keys on the remote
to navigate in the menu.
2
Highlight icon and press 4.
Move to and press 2.
Move to {TEST TONE} and press 2.
OFF
ON
DIGITAL OUT
CNTR DELAY
NIGHT MODE
REAR DELAY
TEST TONE
TEST TONE
3
Press 34 to select a setting.
Adjusting the delay time
4
Press 34 to highlight one of the options
below at a time, then press 2.
DIGITAL OUT
CNTR DELAY
NIGHT MODE
REAR DELAY
TEST TONE
SET CENTER DELAY
OFF 5ms
{CNTR DELAY} – Select this to set the
delay time in relation to the listening
position/distance for the center speaker
(5ms, 3ms, 2ms, 1ms or OFF.)
{REAR DELAY} – Select this to set the
delay time in relation to the listening
position/distance for rear speakers (15ms,
12ms, 9ms, 6ms, 3ms or OFF.)
5
Press 1 2 to adjust the settings that
best suit your surround sound needs.
6
Press OK to confirm.
Helpful Hint:
– Use longer delay time settings when the
rear speakers are closer to the listener than
the front speakers.
Adjusting the speaker output levels
You can adjust the rear speakers, center
speaker and subwoofer output levels by
comparing the sound from the front
speakers.
● Press the respective buttons on the
remote (
REAR +-, CENTER +-
and SUBW +-) to adjust the output
level between -15dB ~ 10dB.
Helpful Hint:
– If you have selected Stereo mode,
adjusting the center and rear speakers’
volume level will have no effect.
Getting Started
TIPS: To return to the previous menu, press
1.
To remove the menu, press SYSTEM MENU.
001-037-MRD120-37-Eng 18/03/2004, 02:19 PM 18