Connections to tv with audio video inputs, Hooking up your vcr – MITSUBISHI ELECTRIC HS-HD1100U User Manual
Page 9
7
IMPORTANT
Your TV Owner’s Guide may have additional
suggestions for audio video hookups.
To connect your VCR to a mono (non-stereo) TV,
connect only the white AUDIO OUT L of the VCR
and the white AUDIO INPUT of the TV. Since the
TV is not stereo, you cannot take advantage of your
VCR’s Hi-Fi stereo sound.
If you have an older TV without audio video inputs,
simply connect only the antenna or cable as shown
on page 5 or 6.
Connections to TV with Audio Video Inputs
Because you purchased a Hi-Fi VCR, you will want to
take advantage of its superior sound capability and
connect it to a stereo TV system with audio and video
inputs. This connection also helps maintain the best
picture quality.
1
Connect the red and white audio cable to AUDIO
OUT R (right) and AUDIO OUT L (left) on the VCR.
Connect the other end to the TV’s AUDIO INPUT
RIGHT and AUDIO INPUT LEFT. Match the colors of
the connectors to the cables.
2
Connect the yellow video cable to VIDEO OUT on
VCR. Connect the other end to VIDEO INPUT on the
TV.
3
Set the RF converter to OFF. See page 48 for
instructions on this setting, which can be done at a
later time.
Hooking Up Your VCR
INPUT-1
INPUT-2
OUTPUT
MONITOR/TUNER
S-VIDEO
VIDEO
L (MONO)
R
AUDIO
AUDIO
VIDEO
OUT
OUT
L
R
L
R
R
R
L
White
Red
Yellow
supplied audio video cable
White
Red
Yellow
TV Rear Panel
VCR Rear Panel