Advanced options, Advanced features – MITSUBISHI ELECTRIC HS-HD1100U User Manual

Page 52

Advanced Options

Using the remote control to operate your TV

The HS-HD1100U remote control can operate many of the frequently-used
functions of your TV. You only need one remote to operate both your VCR and TV.

The HS-HD1100U remote control is pre-set to operate Mitsubishi televisions, but it
can also operate TVs from other manufacturers. To set your remote control for
your particular brand of television, follow these instructions.

setting up your remote control to operate your TV

Turn off your TV.

On the HS-HD1100U remote control, set the VCR/TV slide switch to the TV
position.

While holding in SP/EP, press the code listed that corresponds to the brand of
your TV.

Press TV POWER on the HS-HD1100U remote control. Once your TV has
turned on, your remote is set up to operate your brand of TV.

If your TV does not turn on, repeat step 3 using the next code listed for the brand of
your TV.

If none of the codes listed for the brand of your TV work, then repeat step 3 several
times, using a different code button until one works. The possible code buttons
are: 0, 1-9, MUTE, VOLUME

ª,º, CHANNELª,º and INPUT.

You do not need to perform this set-up again until you change the batteries, set up
your remote for another brand of television, or you get a new TV.

Once you have correctly set your remote control to operate your TV, you will be
able to use the TV POWER, CHANNEL, VOLUME, and number buttons to operate
your TV.

IMPORTANT

Because of variations among models, some or all codes may not work, or
they may operate different functions than expected for your particular TV. If
this occurs, you may need to use your TV remote control.

Sometimes manufacturers will change the remote control codes for their
products, or they will use more than one code. If this is the case, your
remote may not be able to control your TV.

When you replace the batteries in your remote, the remote may return to its
initial setting (code button 1). Repeat the steps above to reset your remote
control. If you enter a new code, the previous code will be erased.

operating your TV with the HS-HD1100U remote control

Set the VCR/TV slide switch to TV position on the HS-HD1100U remote control
to tell the remote that you want to operate the TV.

Point the remote control towards the TV and press the desired buttons. To
once again control the VCR, set the VCR/TV slide switch to VCR position.

Advanced Features

Mitsubishi
Fisher
G.E.
Goldstar
Hitachi
JVC
Magnavox
NEC
Panasonic
Pioneer
Philips
Proscan
Quasar
RCA
Sanyo
Sharp
Sony
Toshiba
Zenith

1, 2, 3
0
VOLUME

2, 9
8
MUTE
4
2, 9
CHANNEL

6
4
VOLUME

CHANNEL

VOLUME

0
3, 5
VOLUME

7
INPUT

Brand of TV

Brand code

buttons

VCR