MITSUBISHI ELECTRIC WD-65000 - Manual (Page 27)

27
Part III : Setup
Programming the Remote Control: T
o
Control Other
A/V Products
Programming the Remote Control: To Control Other A/V Products
Figure 5. Programming the remote to control your
A/V receiver.
After entering the correct codes in each
position of the remote control, use the slide
switch to select which product will respond
when an operational button is pressed. If you
enter a code from the AUDIO chart while the
slide switch is set to TV, the volume and mute
functions change to match the A/V receiver.
This is useful when using an A/V receiver
with the TV all the time. In all other cases,
only one of the below devices is allowed for
each slide switch position.
TV position:
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
VCR position:
VCR
DVD position:
DVD
LD Player
Audio position:
A/V receiver
Mitsubishi CD player
[If you have a Mitsubishi A /V
receiver, the audio position may be used in conjunction with
select Mitsubishi CD players. Your audio position must be
programmed to either 010 or 011. Plug the CD player power
cord into a switched outlet on the back of your A /V receiver.
Pressing the POWER button will then turn on your A/V receiver,
in turn, turning on your CD player. On select CD players, the
transport controls (FF, PLAY, REW, etc.) in the audio position
will operate the CD player.]
Figure 4. Programming the remote to control your
DVD/LDP.
If the slide switch is set to TV when
you enter an A/V receiver code, VOL-
UME and MUTE will control the A/V
receiver rather than the TV. To return
volume and mute control to the TV, set
the slide switch to TV, press and hold
POWER and enter 000. Some manufacturers may change their
products, or they may use more than
one remote control system. If this is
the case, your remote control may not
be able to operate your VCR, DVD,
cable box, satellite receiver, or A/V
receiver.
POWER
DVD/LD Player Codes
Code to enter:
To reset to default code, enter 000
DVD/LDP brand
Mitsubishi (DVD)
Mitsubishi (LD)
Panasonic
Pioneer DVD (LD)
Sony
Toshiba
003
016, 017
250
252 (, 016, 017)
254
253
If your
DVD
code is not
listed here,
please see
page 60 for
a complete
listing.
TV AUDIO
CABLE/DBS/DTV DVD
VCR
1
3
2
POWER
TV AUDIO
CABLE/DBS/DTV DVD
VCR
Code to enter:
To reset to default code, enter 000
Audio brand
Mitsubishi A/V receiver
Mitsubishi CD player
Denon
Kenwood
JVC
Onkyo
Pioneer
Sony
Yamaha
Set M-VR1000 or M-VR800 to 015
Set M-VR900 or M-VR700 to 010
010, 011
234, 235, 236
200, 208
232, 233
209, 214
205, 207
222
201, 202
If your
audio
code is not
listed here,
please see
page 60 for
a complete
listing.
A/V Receiver Codes
1
3
2