Philips Magnavox MC132DMG - Manual (Page 44)

44 SmartLock (cont’d)
SMARTLOCK
Enter Your Access Code
> SMARTLOCK
REVIEW
EXIT
PRIM. SETUP
VCR PROGRAM
VCR SETUP
PRESS B
_ _ _ _
SMARTLOCK
Enter Your Access Code
X X X -
SMARTLOCK
BLOCK
> CHANGE CODE
SELECT KL CHOOSE B
TO END PRESS EXIT
• To protect the privacy of the
access code, an X will appear on
the screen instead of the number
you enter.
• If a “Wrong Code...” message
appears on the screen after you
complete step 5, you entered the
wrong numbers in the Confirm
Code space. Repeat the steps on
this page.
• You cannot use the default code
after you set up your personal
access code.
• If a power failure occurs, the
default code, 0711, will be the
active access code again.
• If you connect the power cord to
an AC outlet that is controlled by
a wall switch, your personal access
code will be erased every time you
turn off the power at the wall
switch. The default code will be
the active code again.
Helpful Hints
New Code
Confirm Code
_ _ _ _
_ _ _ _
To change the access code, follow these steps.
1 Press the MENU button.
2 Press the PLAY/▲ button or the STOP/▼ but-
ton to select SMARTLOCK. Then, press the
F.FWD/B button.
6
Press the STATUS/EXIT button.
4 Press the PLAY/▲ button or the STOP/▼ but-
ton to select CHANGE CODE. Then, press
the F.FWD/B button.
5
Use the Number buttons to enter your desired
access code in the New Code space. Then, enter
the same code in the Confirm Code space.
Your new access code should be recorded. You will
return to the SMARTLOCK menu.
3 Use the Number buttons to enter your old
access code.
The default code is 0711. If you have never set up your
personal access code, use 0711 now.
After you enter the code, the SMARTLOCK menu will
appear.
TRACKING MUTE REC/OTR
SPEED MEMORY
0
8 9 7
5 6 4
2 3 1
PAUSE/STILL
ALT.CH
STOP
F.FWD
PLAY
REW
VOL.
STATUS/EXIT
MENU
POWER SLEEP/WAKE UP
CH.
CLEAR
1
6
2,4
3,5
MC132DMG/MC192DMG 3/22/02 1:21 PM Page 44