Monitor Audio GOLD SIGNATURE GS FX User Manual

Page 7

Setting up the GS FX (Optimum Performance)

12 volt Trigger.

When DVD soundtracks are made, they are done so with the original cinema
reproduction in mind. In movie theatres, there are a greater number of speakers than
discreet channels. Because of this, you get an effect that encompasses the viewer a lot
more, and the imaging from front to back, and left to right is a lot more seamless. The
closest to a cinema the majority of people can practically have is a 7.1 system. This is
where the 12 volt trigger comes into its own.

When you have a 7.1 system set up, and the DVD that is being played has been set up to
recognise 7.1, the AV ampliﬁer will see this and switch the speaker to dipole mode via
the 12 volt trigger. If the DVD is only 5.1, the AV ampliﬁer will also see this and not send
the signal to the GSFX, therefore enabling it as a full range speaker.

The trigger inputs can be seen in the below image, above the speaker terminals. This is
connected to your AV ampliﬁer/ receiver, and determines the mode of the GSFX (mono/
dipole). For the trigger to work, the monopole/ dipole switch on the front needs to be
set to ‘monopole’. Please refer to your AV ampliﬁer manual for further instruction.

This manual is related to the following products:

GOLD SIGNATURE GS LCR