Matrox Electronic Systems Matrox MXO User Manual
Page 28
20
Chapter 3, Installing Your Matrox MXO Software and Configuring Your System
4
Under
Video Output Control
, from the
Set analog video as
menu, select
the type of analog video output you want by selecting
Component
, or
Composite & Y/C
.
5
Under
Genlock Control
, for
Genlock source
select one of the following:
$
Internal
Select this to genlock to MXO’s internal reference signal. Select
this option only if you don’t have an external sync generator connected to
the REF IN on your MXO.
$
External
Select this if you connected an external sync generator to the
REF IN on your MXO.
The status of your genlock source will be displayed next to
Genlock status
as
Locked
or
Not Locked
to indicate whether or not Matrox MXO is
presently locked to your genlock source.
6
If you select
External
as the genlock source, from the
Genlock standard
menu, select your external genlock source’s video standard (this setting is
not applicable if you select
Internal
as the genlock source).
¡ Important
To ensure good output results, make sure that your genlock
source’s video standard matches the standard of your project.