Morphy Richards 40743 - Manual (Page 5)

5
FILLING A
1 Make sure that the iron is not
plugged in, then set the steam
dial ‹ to ‘0’ position before
filling the iron with water.
2 Lift up the filler cap › and fill
the water through the filling hole
into the water tank „, using the
beaker provided  A.
The tank holds 350ml of water.
After filling, replace the filler cap.
IN HARD WATER AREAS, THE
USE OF DISTILLED OR
DEMINERALISED WATER IS
RECOMMENDED.
WARNING: Never use battery
topping up fluid or water
containing any substances
like starch, or sugar, or
defrosted water from a
refrigerator.
3 Always pour out the remaining
water after use.
WARNING: When filling your
iron with tap water, always
use the beaker provided.
Never fill directly under the
tap.
TEMPERATURE
CONTROL
B
1 Plug in the iron and switch on.
On certain models, the water
tank „ will illuminate.
2 Set the temperature control dial
to the temperature required B,
but don’t start ironing
immediately. If you wait a few
minutes, the iron will stabilise at
the required setting.
• Your Morphy Richards iron is
fitted with a temperature
indicator light ‚ which will go
on and off whilst you are ironing.
This is perfectly normal as it
shows that the iron is
maintaining the heat setting you
have chosen.
• It is always a good idea to begin
with cool fabrics and work up to
higher settings. An iron heats up
quicker than it cools down so
you will save time and energy.
FEATURES OF YOUR
IRON
Dry ironing
You can use your iron as a dry
iron only. Make sure the variable
steam control ‹ is set to the ‘0’
symbol.
Any temperature setting may be
used depending on the
garment. The spray feature may
be used, provided there is water
in the tank (see ‘Filling’ section).
You do not need to put any
water in the tank when dry
ironing only.
Water Spray
C
Press the spray button ⁄ and
aim the spray of water at
stubborn creases. You can do
this whilst dry ironing providing
there is water in the tank. When
using the water spray it may be
necessary to push the button a
few times to get the spray pump
primed.
B
C
⁄
A
For details of other Morphy Richards products, please see our website:
RN40743 MUK Rev6:40715 rev3 27/03/2009 14:18 Page 5