Metra Electronics MAZDA 6 2009 99-7511S - Manual (Page 6)

99-7511S KIT ASSEMBLY
4
DOUBLE DIN/STACKED ISO MOUNT
UNIT(S) PROVISION
Cut and remove the center bar from
the Radio Housing. (Figure B) 2
Snap the Double DIN brackets to the
inside edge of the Radio Housing.
(Figure C) 3
Slide the Double DIN or stacked ISO
mount unit(s) into the bracket/radio
housing assembly and secure to the
assembly using the screws supplied
with the unit(s). Snap the DDIN Trim
Plate onto the front of the Radio
Housing. (Figure D) 4
Continue to final assembly.
* Note: Refer also to the instructions included with the aftermarket radio.
A
REAR OF RADIO HOUSING
FILLER TRIM PANEL
B
C D
Attach the filler trim panel to the back
of the radio housing at the bottom
edge. (Figure A) 1