Multi-Tech Systems BL-Series User Manual
Multi-Tech Systems Computer hardware
Table of contents
Document Outline
- Contents
- Chapter 1 - Introduction and Description
- Chapter 2 - Installation and Connection
- Chapter 3 - Software Configuration and Modem Basics
- Chapter 4 - Manual Dial and Automatic Answer
- 4.1 Introduction
- 4.2 Dialing/On-Line/Answering
- 4.3 Automatic Leased Line Restoral Operation
- 4.4 Manual Dial Backup Call Termination
- 4.5 Dial Backup and Leased Line Restoral
- 4.6 Dial-Up Operation
- 4.7 Manual Call Origination
- 4.8 Automatic Answering
- 4.9 Manual Answering
- 4.10 Handshaking Details
- 4.11 Call Termination
- Chapter 5 - Command Mode
- 5.1 Introduction
- 5.2 Summary of AT Commands
- 5.3 Result Codes
- 5.4 Dialing Commands
- 5.4.1 Dialing Action Commands
- 5.4.2 Dial Modifier Commands
- 5.4.3 Phone Number Memory Commands
- 5.4.4 Configuration and Default Storage Commands
- 5.4.5 Command Response (Result Code) Commands
- 5.4.6 Phone Line Conditioning Commands
- 5.4.7 RS-232C Interface Control Commands
- 5.4.8 Error Correction Commands
- 5.4.9 Flow Control Commands
- 5.4.10 Compression, Error Correction, Flow Control, Pass-Through and Pacing Commands
- 5.4.11 Speed Conversion Commands
- 5.4.12 Immediate Action Commands
- 5.4.13 Line Probe Commands (2834 Series only)
- Chapter 6 - S-Registers
- Chapter 7 - Callback Security and Remote Configuration
- Chapter 8 - Modem Testing
- 8.1 Introduction
- 8.2 Local Analog Loopback Test/V.54 Loop 3
- 8.3 Digital Loopback Test/V.54 Loop 2 (Local/Manual)
- 8.4 Digital Loopback Test/V.54 Loop 2 (Remote/Automatic)
- 8.5 Back-to-Back Test
- 8.6 Synchronous Mode Testing
- 8.7 Local Analog Loopback Test (Synchronous Mode)
- 8.8 Digital Loopback Test (Local/Manual) (Synchronous Mode)
- 8.9 Digital Loopback Test (Remote/Automatic) (Synchronous Mode)
- Chapter 9 - DIP-Switch Settings
- Chapter 10 - Warranty, Service and Tech Support
- Appendixes
- Appendix A - Troubleshooting
- Appendix B - ASCII Character Code/Hex/Decimal Conversion Chart
- Appendix C - Dial Pulse and Tone-Dial Frequencies
- Appendix D - Command Summary
- Appendix E - DIP-Switch Summary
- Appendix F - S-Register Summary
- Appendix G - Result Code Summary
- Appendix H - V.25bis Operation
- Appendix I - MultiModemBL Cables
- Appendix J - RS-232C Interface Specifications
- Appendix K - Regulatory Information
- Index