Monte Carlo Fan Company 5DH52 - Manual (Page 4)

Install the screws removed in step # 5 and
tighten all screws.
11
Attach blade brackets to blades using the blade
bracket screws and washers provided.
12
For control of fan and optional light from wall
location, follow diagram above. NOTE: A pro-
fessional electrician is recommended for
this type of installation.
8
Lift decorative motor housing to slide over
mounting plate, align with the two remaining
screws in the mounting plate with the “L” shape
holes and twist clockwise to lock.
10
Wiring option with wall speed control
Li
gh
t
Sw
it
ch
Fa
n
Sw
it
ch
Wall
Control
Remove plastic shipping stabilizer tabs from
motor, if present. The screws, washers and
motor pads are pre-installed to the blade hold-
ers. Attach blade assembly to motor by tighten-
ing first screw one turn, then tighten second
screw securely. Then, go back and tighten first
screw securely.
13
After attaching blade; reinstall the switch hous-
ing using the three screws previously removed.
14
Lift motor into place aligning studs on mounting
plate with holes on the motor bracket. Install
and tighten four locking nuts to studs. Tighten
firmly. Use 7/16” wrench or pliers.
9
Mounting
Plate
Motor
Bracket
Wrench
Installation
After installation, please refer to operation, maintenance and troubleshooting
sections in this manual. If your fan is packaged with a light kit or
if you wish to install a separately purchased light kit, please refer
to the insert sheet titled: Light Kit Installation
Note:
For pullchain controls, follow diagram above.
Make sure that all exposed wiring is secured
inside wire nuts. Note: Wires from house may
vary in color and may not include ground wire.
After wiring is conplete, gently push wires into
junction box with wire nuts pointing upward.
Refer to point 3 of safety tips.
7
House Fan
Black
White
Ground
Black
White
Green(Bracket)
Blue *
Standard wiring option
Green(Downrod)
* Attach blue wire
only if attaching
light kit with fan
Secure with twist-
lock wire connectors
(included)
Fiber
washers
Shipping
stabilizer
tab