Morphy Richards Turbo steam iron - Manual (Page 4)

4
B Be effo orre e u us se e
Note: The Steam facility should only be used
on garments which are suitable for ironing at 2
and 3 dot settings. (Garments marked with 2 dot
recommendation should, if required, be ironed at
the lower end of the steam range).
Textiles and clothes are supposed to carry
ironing instructions. If they don’t you should
follow the temperature guide on page 3, but be
sure to test the temperature by ironing the hem
of the garment or similar area first. If you turn
the control dial down from a hot setting to a
cooler setting, wait until the iron temperature
has stabilised before you continue ironing.
F Fiilllliin ng g
Before filling your iron make sure that it is not
plugged in and ensure that the iron is in the
‘steam off’ position. To do this slide the steam
button to the ‘down’ position
E/F.
Remove the water tank cap and hold the iron
by the handle. Fill using the beaker provided A.
Your iron has a large
capacity tank which can
hold 2 beakers of water.
After filling, replace the
water tank cap to prevent
any water escaping from
the tank during ironing
B.
Your iron has been
specially designed for use
with tap water. Never use
battery topping up fluid or water containing any
substances such as starch or sugar, or defrosted
water from a refrigerator. In hard water areas
the use of distilled or demineralised water is
recommended. Warning: When filling your
iron with tap water always use your
beaker. Never fill directly under the tap.
T Te em mp pe erra attu urre e c co on nttrro oll
Plug in the iron and switch on. Set the
temperature control dial
C to the temperature
required, but don’t start
ironing immediately. If
you wait a few minutes,
the iron will stabilise at
the required setting.
Your Morphy Richards
iron is fitted with an
indicator light which will
go on and off while your are ironing. This is
perfectly normal as it shows that the iron is
maintaining the heat setting you have chosen.
For the correct temperature always set the
control dial with the required setting at the
bottom of the dial nearest the back of the iron.
F Fe ea attu urre es s o off y yo ou urr iirro on n
Temperature indicator light
The temperature indicator light shows that
the iron is warming up. When the required
temperature is reached the light will go out and
will cycle on-off during operation.
Dry Ironing
You can use your iron as a dry iron only.
Make sure the steam control is off. Any
temperature setting may be used depending on
the garment. The spray feature (if fitted) may be
used provided there is water in the tank (see
filling section). The shot of steam feature (if
fitted) may also be used provided the
temperature control dial is set to the steam
range
C. You do not need to put any water in
the tank when dry ironing only.
Spray (certain models only)
Press the spray button and aim spray of water
at stubborn creases. The grey region shows the
spray button on different models
D. You can do
this whilst dry ironing providing there is water in
STE
A M RANG
E
A
B
C