Marley Engineered Products 994 - Manual (Page 6)

FAN OPERATION
This ceiling fan has 3-speeds that are controlled by a pull-chain switch. Switch operation is OFF - HI - MED - LOW. The
speed is easily changed by pulling the chain to select desired speed.
REVERSIBLE OPERATION
This ceiling fan is reversible. A slide switch installed either on the bottom of the motor assembly or on the side of the
switch cap will reverse the direction of rotation. This will allow downward movement of air under the fan for summertime
operation, or by reversing the direction of rotation, upward movement of air in the winter to recirculate hot air trapped at
ceiling level. DAMP LOCATION FANS MAY NOT BE REVERSIBLE.
LUBRICATION
The fan motor is constructed with sealed ball bearings which do not require lubrication during the life of the motor.
LIGHT KITS
Accessory light kits are available from your Marley Engineered Products Fan distributor. The wiring instructions for these kits
are packed in the light kit carton.
— 6 —
3. Repeat the above procedure for the remaining blades.
4. Without delay, turn the fan on high speed for approximately one (1) minute.
5. Turn the fan off and let it stop by itself. DO NOT TOUCH BLADES OR HUB until the fan has stopped completely.
6. Being careful not to disturb the blade arm location on the motor hub, tighten all screws on the hub. This procedure
allows final positioning of the blades to eliminate fan wobble. If wobble persists, loosen blades and repeat Steps 4
through 6.
NOTE: IF AFTER PERFORMING THE ABOVE PROCEDURE A WOBBLE IS STILL
APPARENT, SWITCH ONE PAIR OF ADJACENT BLADES WITHOUT
COMPLETELY TIGHTENING THE SCREWS. REPEAT STEPS 4 THRU 6.
Use only Light Kits marked “Suitable for use in Damp locations” with Damp location fans.
DO NOT ATTEMPT TO CHANGE FAN DIRECTION WHILE UNIT IS OPERATING!
BEFORE ATTEMPTING TO CLEAN OR SERVICE YOUR CEILING FAN, DISCONNECT ELECTRIC POWER
SUPPLYING THE FAN OUTLET BOX TO AVOID ELECTRICAL SHOCK OR PERSONAL INJURY.
a CAUTION
!
WARNING
!