Marantz VP-12S1s - Manual (Page 7)

3
INTRODUCTION
ENGLISH
z COMPONENT VIDEO IN
Y, P B /C B , P R /C R connectors.
Connect the COMPONENT VIDEO output from video
equipment or an A/V processor/receiver with a component
video output.
x S-VIDEO IN
Connect the S-VIDEO output from a video equipment.
c VIDEO IN
Connect the composite video output from a video equipment.
v RGB IN
Connect the analog RGB output from a computer equipment.
b AUX DV IN
Connect the i.LINK(DV-SD format) output from a video
equipment.
n AUX OPTICAL
Connect the optical input from an audio equipment.
Audio out terminal of DV-IN signal.
VP-12S1
z c
m ⁄4 ⁄6 ⁄5 ⁄0 , ⁄3 ⁄2
⁄7
x n b v
⁄1 .
Right Side and Rear
m AUX AUDIO OUT (DIGITAL)
Connect the COAXIAL input from an audio equipment.
Audio out terminal of DV-IN signal.
, REMOTE CONTROL IN/OUT
By connecting this projector to another Marantz audio
component using a supplied System Control cable, you can
remotely operate the components as a single system.
• When connecting to component with a remote sensor
(such as the SR-14,SR-18,SR-19), be sure to connect the
"REMOTE CONTROL IN" jack of this projector to the
"REMOTE CONTROL OUT" jack of the component with
the remote sensor.
• When connecting to component which is not equipped
with a remote sensor, be sure to connect the component
to the "REMOTE CONTROL OUT" jack of this projector.
. REMOTE switch (EXTERNAL/INTERNAL)
When using this projector independently, set this switch to
"INTERNAL". When using this projector in a system with a
Marantz DVD player or AV Receiver equipped with a remote
sensor, set the switch to "EXTERNAL".
⁄0 TRIG.1(TRIGGER 1)
When the unit is turned on, 12V is output. When the unit is
turned off, no voltage is output. This allows such as a powered
up/down screen,whenever the projector is turned on or off.