Mr. Coffee mrx35 - Manual (Page 18)

Water Filtration Disk Replacement
Your water filtration disk will need to be replaced once a month (approx. 30 brew cycles).
If the machine will not be in use for an extended period of time, rinse the water filter with
running water and clean the coffeemaker before use.
Cleaning the Decanter
Hard water can leave a whitish stain on the decanter, and coffee may then turn this stain brown.
To remove decanter stains:
1. Fill the decanter with a solution of equal parts water and vinegar and let the solution stand
in the decanter for approximately 20 minutes.
2. Discard the solution, then wash and rinse the decanter.
Do not use harsh abrasive cleaners that may scratch the decanter,
scratches may cause the decanter to break.
17
F
igure
15
Suggested Decalcifying Interval
Type of Water Cleaning Frequency
Soft Water Every 80 Brew Cycles
Hard Water Every 40 Brew Cycles
or when RED CLEAN light is flashing.
5. Discard the cleaning solution and rinse the decanter
thoroughly with clean water.
6. Fill the water reservior with clean, fresh water.
7. Place the empty decanter back on the coffeemaker,
centered on the warming plate.
8. Remove and discard the paper filter used during the
cleaning cycle. If a MR. COFFEE ® permanent filter was
used during cleaning, remove it and rinse it thoroughly
before replacing it in the filter basket.
9. Begin brewing and allow the full brew cycle to complete.
10. Repeat steps 5 through 9 one more time.
Your coffeemaker is now clean and ready to brew the next
pot of delicious, hot coffee!