Setting the clock and delay brew time – Mr. Coffee mrx35 User Manual

Page 10

SETTING THE CLOCK AND DELAY BREW TIME

To Set the Clock:

1. Plug the power cord into a standard electrical outlet.

The clock will flash on the control panel to indicate
that the time has not been set yet.

2. Press and hold the HOUR and then the MINUTE buttons

until you reach the current time. The AM or PM indicator
will light at the bottom of the display (Figure A).

The clock is now set!

NOTE: Pressing any button before setting the clock will cause
the clock to start keeping time from 12:00 a.m. You must set
the clock if you want to use the Delay Brew feature.

To Set the Delay Brew Time:

While the display is in the clock mode, simply press the
SET DELAY button (Figure B) and, while the DELAY BREW
yellow light is flashing, set the delay brew time by pressing
the HOUR and then the MINUTE buttons (Figure C). The AM or
PM indicator will light at the bottom of the clock display.

Within a few seconds the display will change
to the current time.

The Delay Brew Time is now set!

NOTE: To activate the DELAY BREW cycle,
see the

Brewing Coffee Later section.

To check the programmed time, push the SET DELAY
button. The display will show the time you have
programmed the coffee to brew. If you press the
SET DELAY button again or wait a few seconds,
the display will switch back.

igure