Morphy Richards 40725 - Manual (Page 6)

66 UUKK HHeellpplliinnee 00887700 006600 22661155 RReeppllaacceem meenntt PPaarrttss 00887700 116677 66664466 IIrreellaanndd HHeellpplliinnee 11880000 440099111199
Press the shot of steam button
fi fi to obtain a burst of extra
steam for ironing out creases in
heavy material such as denim
etc.
The shot of steam can be used
whilst dry ironing, providing
there is water in the tank, and
the temperature control is set
within the steam range.
Do not use shot of steam at
temperatures below the steam
range (2-DOT) shown on the
control dial.
Note: For optimum steam
quality, do not operate the shot
more than three times in
succession.
Vertical steam
Hold the iron in a vertical
position between 1cm and 2cm
away from the item E E . Press
the shot of steam button fi fi ,
this will create vertical steam.
This feature is especially useful
for removing creases from
hanging clothes, curtains, wall
hanging, etc.
Note; For optimum steam
quality, do not operate the shot
more than three times in
succession.
No drip system
Your iron is fitted with a no drip
system which is designed to
prevent water escaping from the
soleplate when the iron is too
cold.
During use, the no drip system
may emit a loud click,
particularly during heat-up or
whilst cooling down. This is
perfectly normal and indicates
that the system is functioning
correctly.
Auto shut-off
(certain models only)
If your iron is fitted with the auto
shut-off function it will
automatically shut down after a
set period.
If the iron is left unattended in
the horizontal position it will
shut down after 1 minute. When
this occurs, the indicator light
will flash and a beep will be
heard.
If it is left in the vertical position
it will shut down after 8 minutes.
To reactivate the iron gently
shake it, the temperature
indicator light will come on
indicating the iron is warming
up and wait for the iron to heat-
up as normal.
LIFE LONG ANTI-
SCALE SYSTEM
(certain models only)
The life long anti-scale system
reduces scale deposits and
helps prolong the life of the iron.
EMPTYING AND
STORING
When you have finished ironing,
unplug your iron. Ensure that
the steam to dry iron selector
switch ⁄ ⁄ is set at the
position, lift up the fill cap and
empty any remaining water out
of the filling hole F F..
Do not store in the box, but in
an upright position, so that any
drops of water remaining
cannot leak out and discolour
the soleplate G G..
Important: The flex can be
damaged if wound too tightly
around the iron after use. Make
a loose loop with the flex and
wrap it around the iron. The iron
must be cool before winding the
flex and storing on its heel.
MAINTENANCE
Self clean feature
11 Half fill the iron with water.
22 Place the iron on its heel.
33 Connect to a mains supply
outlet
44 Turn the temperature dial to
‘MAX’ setting
E E
F F
G G
40725 rev4 28/8/07 15:32 Page 6