McIntosh MCC404/MCC404M - Manual (Page 18)

18
Specifications
Specifications
Power Output Per Channel
100 watts into 4 ohm loads and 200 watts into 2 ohm loads
is the minimum sine wave continuous average power out-
put per channel all four channels operating.
Power Output Bridged
400 watts into 4 ohm loads is the minimum sine wave con-
tinuous average power output.
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is:
0.005% for 4 ohm loads
0.007% for 2 ohm loads
0.007% for Bridged Mode with 4 ohm loads
Dymanic Headroom
1dB
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 50,000Hz
Sensitivity
0.5Volts
A-Weighted Signal To Noise Ratio
105dB (1.5V)
One Band Equalizer
Center Frequency is variable from 40Hz to 2,000Hz, level
variable ±12db, Q fixed at 2
High Pass Filter
Variable from 5Hz to 5,000Hz, 12 db per octave
Low Pass Filter
Variable from 50Hz to 5,000Hz, 12 db per octave (24 db
per octave in Bridged Mode)
Subwoofer Output
Low Pass filtered at 200 Hz with a 6db per octave slope
(level variable ±12db when using optional McIntosh Exter-
nal Subwoofer Rotary Control)
Intermodulation Distortion
Maximum Intermodulation Distortion if instanta-
neous peak output per channel does not exceed
twice the rated output, for any combination of fre-
quencies from 20Hz to 20,000Hz, with all channels
operating is:
0.005% for 4 ohm loads
0.007% for 2 ohm loads
0.007% for Bridged Mode with 4 ohm loads
Input Impedance
12,000 ohms
Power Requirements
12 Volts DC, 3.5 amps (idle) - 70 amps (100 watts)
Dimensions
12.25 inches (31.1 cm) wide, 3.0 inches (7.6 cm)
high, 18.4 inches (46.7cm) depth
Weight
20.2 pounds (9.2 Kg) net, 23.2 pounds (10.5 Kg)
in shipping carton