MTD 428C - Manual (Page 8)

8
SECTION 3: KNOW YOUR TILLER
Figure 9
WARNING: Read, understand, and follow
all instructions and warnings on the
machine and in this manual before
operating.
Gear Selection Handle
The gear selection handle is located on the front of the
handle assembly (right handle on Model 420 Series). It
is used to select NEUTRAL, REVERSE, or one of the
FORWARD modes.
This tiller is designed for the gear selection handle to be
moved while the engine is running. (It will be difficult to
obtain all four positions with the engine off.) Pull or push
the handle so that the indicator on top of shift cover
points to the area of the operating mode desired.
See Figure 9.
NOTE: If difficulty is encountered in moving the gear
selection handle, refer to following helpful hints. To shift
into forward or reverse wheel drive, move tiller forward
slightly then backward to allow the gears to
synchronize.
To shift into forward wheels and tine drive, push
forward slightly on the gear selection handle and slowly
engage the clutch handle allowing the gears to
synchronize. To stop forward movement and tine drive,
release the clutch handle. Do not shift gears with the
clutch handle engaged except when engaging the
tines.
Reverse
Reverse wheel drive only.
Neutral
Transmission is in neutral.
Wheels Forward
Forward wheel drive only.
Tines Reverse
Forward wheel drive and reverse tine drive.
WARNING: Make certain unit is in
NEUTRAL when starting the engine.
Clutch Handle
The clutch handle is located beneath the handle.
Squeezing the clutch handle against the handle
engages the wheel and tine drive mechanisms.
See Figure 9.
Throttle Control
The throttle control lever is located on the engine. It
controls the engine speed and stops the engine.
Choke Lever
(If Equipped)
The choke lever is located by the throttle. It is used to
enrich the fuel mixture in the carburetor when starting a
cold engine.
Gear Selection
Handle
Handle Height
Adjustment Lock
Clutch Handle
Depth Stake
Model 410 Series
Model 420 Series
Gear Shift Rod
Handle
Adjustment Rod