Metrologic Instruments 1070 - Manual (Page 15)

A
PPENDIX
B
Pin Assignments for the Mil spec Connector
Each TECH 10®scanner has a 19-pin male Mil spec connector that is on the side of the unit. To connect the
scanner to the host device, use a communication cable with a female Mil spec connector. The communication
cable may include a power transformer or it may be designed to draw power directly from the host device. This
item can be ordered when the scanner is purchased.
The following is a list of the pin assignments. The pin numbers are impressed on the male Mil spec connector The
Tech 10
® scanners are manufactured by Metrologic at its Blackwood, New Jersey, U.S.A. facility. For easier
reference, refer to Figure 5 for pin locations.
PIN
FUNCTION
A R
Data
B RTS Output
C Signal Ground
D CTS Input
E R Data Return
F RS-232 Output
G Clock in
H Clock In Return
J Clock
Out
K Shield Ground
L DTR Input
M Clock Out Return
N Power to Scanner & 24 VDC
P Earth
Ground
R Power
Ground
S RS-232 Input
Figure 5
11