beautypg.com

Installation instructions continued, How to finish unpacking, Connecting to the mains terminal – Moffat MDB900 User Manual

Page 34: Important, Warning

background image

34

Installation instructions continued

How to finish unpacking

• Place packed appliance next to the space

in which it will be installed.

• Remove the appliance packing except for

bottom tray, which should be left in position
until the appliance is ready to be fitted into
its cabinet.

IMPORTANT!

It is imperative that the appliance is left in the
base to protect both the appliance and the floor.

• Ensure the user is given these operating

instructions.

IMPORTANT!

Important: Switch off at the mains, miniature
circuit breaker and if appropriate, remove fuse
before commencing any electrical work.

To remove the mains
terminal cover

• From the rear of the appliance, remove

mains input terminal cover to gain access to
terminal block.

• First remove retaining screw with pozidrive

screwdriver.

• Prise cover loose using screwdriver in

position (1) then lever off with screwdriver in
position (2) at either side.


• Lift cover and remove screw from cable

clamp.

Connecting to the mains
terminal

WARNING!

This appliance must be earthed.

• We recommend you use a new length of

6mm2 twin core and earthed cable to ensure
your safety.

• Make connection as shown below by

proceeding as follows: -

• Pre-form wires to the appropriate shape to

suit fitting into the mains terminal block.

• Strip inner insulation on wires using wire

strippers.