Moffat MDB900 - Manual (Page 25)

25
Care and cleaning
WARNING!
Before cleaning always allow the appliance
to cool down before switching off at the
electricity supply.
Cleaning materials
• Before using any cleaning materials on your
appliance, check that they are suitable and
that their use is recommended by the
manufacturer.
• Cleaners that contain bleach should not be
used as they may dull the surface finishes.
Harsh abrasives and scourers should also
be avoided.
Cleaning the outside of the
appliance
• Do not use abrasive cleaning materials e.g.
abrasive cream cleaners, wire wool pads or
scourers on painted or printed finishes as
damage may occur. Regularly wipe over the
control panel, doors and appliance sides
using a soft cloth and hot soapy water. To
prevent streaking, finish with a soft cloth.
• Stainless Steel cream cleaners are abrasive
and should be avoided as they may dull the
surface finish. Any spillage on the
stainless steel finish must be wiped off
immediately.
WARNING!
Do not attempt to remove any of the control
knobs from the appliance as this may cause
damage and is a safety hazard.
WARNING!
Under no circumstances should the door
assembly be detached from the product for
cleaning.
Cleaning the control knobs and
handles
It is strongly recommended that only hot soapy
water be used for cleaning the control knobs
and handles. ANY OTHER CLEANING
MATERIALS MAY DULL THE SURFACE
FINISH.
Removing and replacing the
wirework runners
• Remove all shelves and furniture from the
oven.
• Hold the wirework at the bottom, unclip from
the cavity side and gently pull towards the
centre of the oven.
• Unhook the runner at the top and remove
from the cavity.
• To replace the runners, hook the wirework
side runner into the cavity, slide back and
press into place.
WARNING!
Ensure the wirework runners are firmly in
position before replacing the oven shelves.
Cleaning inside the ovens
• The vitreous enamel coating in the grill/top
oven and main oven compartments can be
cleaned using normal oven cleaners with
care. Ensure that the manufacturers
instructions are followed and that all parts
are well rinsed afterwards.