Milan Technology MLH-H 1130 - Manual (Page 5)

10Base-T Station to Hub Connection
Use the following procedure to connect a 10Base-T
Ethernet station to the hub.
· Make sure that the hub's slide switch is selected
to NORMAL mode for the 1st port.
· Connect one end of the cable to the 1st port of
the hub and the other end to the station, as shown
in Figure 3.
Interconnecting Hubs
Note the following when interconnecting two or
more hubs:
· Make sure that the primary hub's switch is set to
UPLINK mode for the 1st port and the secondary
hub's switch is set to NORMAL mode.
· Connect one end of the cable to the 1st port of
the hub and the other end to another hub, as
shown in Figure 4a and Figure 4b.
5
Figure 3. Connecting to Station