Makita 5402NA - Manual (Page 11)

11
To remove the blade, press the shaft lock so that the blade
cannot revolve and use the wrench to loosen the hex bolt
counterclockwise. Then remove the hex bolt, outer flange
and blade.
To install the blade, follow the removal procedure in reverse.
BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE
SECURELY.
After installing the blade, lock the lock lever.
When changing blade, make sure to also clean upper and
lower blade guards of accumulated sawdust. Such efforts do
not, however, replace the need to check lower guard opera-
tion before each use.
CAUTION:
• The inner flange has a 25 mm (63/64”) diameter on one
side and a 25.4 mm (1”) diameter on the other. The side
with 25.4 mm (1”) diameter is marked by “25.4”.
Use the correct side for the hole diameter of the blade
you intend to use. Mounting the blade on the wrong side
can result in dangerous vibration.
Hex wrench storage
When not in use, store the hex wrench as shown in the figure
to keep it from being lost.
1. Hex bolt
2. Outer flange
3. Inner flange
4. Saw blade
1 2
3
4
001970
1. Mounting shaft 2. Inner flange
3. Outer flange 4. Hex bolt
5. Blade
1 2 3 4
5
001971
1. Lever
2. Hex wrench
1
2
001972