beautypg.com

Master Lock F-64TPG User Manual

Page 15

background image

15

If a fire is detected, the siren will sound a distinct pulsating tone and the LCD window will flash the
word FIRE. If a Fire Alarm does occur:

1

If a fire is in progress, evacuate the premises immediately! Call the Fire Department from an outside phone.

2

If there is no evidence of a fire, press

RESET

OR insert your I-FOB key into the Touchpad.**

The siren will silence, and the word FIRE in the Touchpad LCD window will stop flashing.

3

Determine which device went into alarm. If you are protected by smoke detectors, the light on the
active detector will be lit. Once it is determined which smoke detector is in alarm, press

RESET

to

reset the smoke detector.

4

If the Fire Zone has reset properly, the words SYSTEM READY should appear in approximately 30
seconds. If the words SYSTEM READY do not appear, press

RESET

again in a few minutes. If the

words SYSTEM READY still do not appear, call for service.

Fire-Zone Trouble

The system is constantly monitoring the Fire Zone to insure the connections to the protective devices
are in good working order.
• If a problem on a Fire Zone is detected, a System Trouble will display. The sounder will activate

and LCD window will display the name of the zone in trouble.

Press the

RESET

button to silence the sounder. Call for service immediately.

*Consult your installer to determine if your system includes fire protection.
**Check if only I-FOB can silence fire alarm: ‰YES ‰NO

F I R E P R O T E C T I O N *

FIRE

RESET

RESET

F-64TPG_OI320A.03_USER_2...

page 15

Friday, September 15, 2006 11:40

Composite