Morphy Richards TURBOSTEAM RN40513 - Manual (Page 4)

4
COMPONENTS OF
YOUR IRON
⁄ Shot of steam button
¤ Spray button
‹ Variable steam control
› Filling hole with cap
fi Spray nozzle
fl Soleplate
‡ Temperature control dial
· Water tank
‚ Temperature indicator light
„ Filling beaker
BEFORE USE
Note: The steam facility should
only be used on garments which
are suitable for ironing at the 2
and 3 dot settings.
When ironing with the steam
facility at the 2 dot setting, the
steam output should be set at
the lower end of the steam
range (see ‘Variable steam’
section).
Textiles and clothes are
supposed to carry ironing
instructions. If they don’t, you
should follow the fabric guide on
page 3, but be sure to test the
temperature by ironing the hem
of the garment or similar area
first.
If you turn the control dial down
from a hot setting to a cooler
setting, wait until the iron
temperature has stabilised before
you continue ironing.
FILLING A
1 Make sure that the iron is not
plugged in and then set the
variable steam control
‹ to the
‘0’ position before filling the iron
with water.
2 Remove the fill cap and pour
water through the filling hole
›
into the water tank ·, using the
beaker provided. One beaker full
of water fills the tank (400ml)
A.
After filling, replace the fill cap. In
hard water areas, the use of
distilled or demineralised water is
recommended.
Never use battery topping-up
fluid or water containing any
substances like starch or
sugar, or defrosted water from
a refrigerator.
3 Always pour out the remaining
water after use.
WARNING: When filling your
iron with tap water, always use
the beaker provided. Never fill
directly under the tap.
fl ‡ ·
A
⁄
¤
‹
›
fi
‚
UK Helpline 0844 871 0953 Replacement Parts 0844 873 0719 Ireland Helpline 1800 409 119
400
350
300
„
40513 rev1:RN40513 MUK Rev1 18/02/2009 11:16 Page 4