MITSUBISHI ELECTRIC DV158 - Manual (Page 9)

5
5 5
Hardware Installation
Your monitor is equipped with an AC adaptor that has a power supply with
a voltage range from 100 to 240 Volts AC at a frequency of 50 to 60 Hz.
Make sure that your local power supply is within the supported range. If you
are unsure, please contact your electricity supplier.
To install your Diamond View DV158 monitor:
1. Make sure that the power to the computer and the power to the monitor
are both turned off.
2. Connect the blue connector
of the monitor’s VGA cable to
the VGA output of the
computer‘s graphics card.
3. Connect the stereo audio
cable from the monitor’s
audio jack to the Audio output
of your computer’s sound
card.
4. Connect power cord to the power adaptor first, and then connect the
power adaptor to LCD monitor.
5. Connect the power cord from the power adaptor to an AC power
socket. Please make sure, that you have easy access to the power
socket so you can disconnect the unit from the power socket should
you need to.
Signal Power adaptor