Merco Savory C-40 - Manual (Page 9)

0 Wire Guard Replacement:
(Refer to Figure #21)
1. Remove left side panel and insulation.
2. Remove the three nuts holding end plate and
remove plate.
3. Slide out wire guard.
4. Insert new wire guard into track. NOTE: Use rear
track for toasting buns or bread. Use forward track
for toasting bread only.
5. Replace end plate, nuts, insulation and side panel.
P P.C. Board Assembly
Replacement:
(Refer to Figure #22)
NOTICE: PROCEED WITH THE BELOW
LISTED STEPS, ONLY, IF YOUR UNIT
CONTAINS THE P.C. BOARD ASSEMBLY.
1. Remove right side panel.
2. Loosen set screw and remove speed
control knob.
3. Remove nut securing potentiometer.
4. Disconnect wires from P.C. Board and
remove screws, nuts and washer holding
guard to toaster frame.
5. Remove board with potentiometer.
6. Install new board assembly reversing
above procedure. (Refer to Wiring
Diagram).
9