Melissa 243-009 - Manual (Page 16)

- After the light goes off, rotate the dial again
until it comes on. Repeat this until all the oil
is melted. After all the oil is melted, the
temperature dial can be set to the desired
cooking temperature.
- Be careful never to add too much solid fat
and always ensure that the level is between
the minimum and maximum indication. After
the fryer has cooled, this type of fat will
solidify.
CLEANING
- Unplug the deep fryer.
- Wait until the unit is completely cool before
cleaning. Show care when touching the
temperature probe of the control box, as this
may still be hot after some time. Do not
immerse the control box in any liquid.
- Follow the section "dismantling the deep
fryer".
- Do not use strong detergents or abrasive
cloths/liquid, as this will damage the deep
fryer. Clean the fryer (except the control box)
with warm soapy water. It may help to soak
the parts for a short time. If you choose to
use a dishwasher, there may be discoloration
of the parts. This will not affect the fryers
performance.
- To clean the control box wipe with a dry
cloth.
- Thoroughly dry all parts.
- Change the oil regularly.
- Clean your deep fryer regularly. This will
prolong the life of the deep fryer.
- To assemble – see the section "assembling
of the deep fryer".
STORING
The unit can be stored with the oil inside. Ensure
that the lid is positioned correctly to avoid dust
getting into the oil.
TEMPERATURE GUIDE
Temperature Time
Breaded fillet
of fish 170° 5-6 min.
Scampi 170° 3-5 min
Chicken breast 175° 3-4 min.
Breaded chicken
pieces 170° 12-15 min.
Onion rings 180° 3 min.
Broccoli fritters 185° 2-3 min.
Celery in batter 180° 2-3 min.
Chips, 1st stage 160° 8-10 min.
Chips, 2nd stage 190° 3-4 min.
ENVIRONMENTAL TIP
An electronic appliance should, when it is no
longer capable of functioning be disposed of with
least possible environmental damage and
according to the local regulations in your
municipality In most cases you can discharge the
appliance at your local recycling center.
THE WARRENTY DO NOT COVER:
- if the above points have not been observed.
- if the appliance has not been properly
maintained, if force has been used against it
or if it has been damaged in any other way.
- errors of faults owing to defects in the
distribution system.
- if the appliance has been repaired or
modified or changed in any way or by any
person not properly authorized.
Owing to our constant development of our
products on both functionality and design we
reserve the right to change the product without
preceding notice.
Importer:
Adexi A/S
Adexi AB
We take reservations for printing errors.
16
AT-058 IM 03/07/03 14:25 Side 16