English – Marmitek 25 User Manual

Page 9

EASYTOUCH 25

4. Release Setup key.

5. Press and release the Touchscreen "CODE" Key.

6. Display shows the Mode Setup Screen. Press and release desired Mode key (TV, VCR,

SAT, etc.) on the rubber keypad. Note The Brand Search Method is not available for
Audio appliance.

7. Display will show the Code Setup Screen. Using the table, press and release the

numerical key (0-6) corresponding to desired Manufacturer. Note - pressing "0"
carries out a full library search same as normal Code Search Method.

Brand CODE

Philips/Radiola/Aristona/Erres 1
Sony/Panasonic/JVC/Sharp Akai/Toshiba/Daewoo

Thomson/Brandt

Telefunken/Saba/Nordmende

Grundig/Blaupunkt

Nokia/ ITT

8. Press and release the Touchscreen "SEARCH" Key.

9. Display will show the Search Setup Screen. Press the Touchscreen "UP" key (or Power

or Play) repeatedly until the Device to be controlled changes channel. Alternatively,
you can use the Channel Up & Down keys. Press and release the Touchscreen "OK"
(or Mute) key to install the Code. Display will return to the Main Setup Screen.
If you accidentally overshoot the Code required, press the Touchscreen "DOWN" or
Channel Down to backtrack through the Library to return to the correct code.
Pressing the Touchscreen "UP" key (or Power or Play) will change direction to forward
again.

10. Repeat this procedure for any other appliance you want to control.

ATTENTION: the Brand Search method does not work for CD and AUDIO.

11. The Brand Search Method entry is now complete. Press and release the Touchscreen

"EXIT" key to return to normal operation.

Notes:
a. When all codes under a Brand have been searched the LED will "error" flash

indicating end of the search and Main Setup Screen will be displayed.

b. The above search procedure assumes that you want to store VCR codes under the

VCR key, Cable codes under CBL, etc. If you want, for example, to store a VCR code
under CBL, etc., then the Mode key must be "primed" for the new appliance. First
follow the "Programming using 3 Digit Code Table" procedure and then enter any
VCR code prior to carrying out the above search steps.

Method B: Programming using the 3 Digit Code Tables
Note: you can dedicate any appliance (TV, DVD, SAT...) to the VCR, DVD, SAT, AUDIO,
CBL: you need first to enter the 3 digit code of the appliance you wish to control (found
in the code book). In any case, follow the method below:

1. Make sure your appliance is switched on (for example TV)

ENGLISH