Marmitek 25 - Manual (Page 16)

16 MARMITEK
7. Learning is now complete. Press and release the Touchscreen "EXIT" key to return to
normal operation.
To Clear all stored Learned Commands under a Mode:
1. Press and hold Setup key until the LED remains on (this occurs after approximately 2-3
seconds) and display shows the Main Setup Screen.
2. Release Setup key.
3. Press and release the Touchscreen "LEARN" Key.
4. Display will show the Mode Setup Screen. Press and release desired Mode key (TV,
VCR, SAT, etc.) on the rubber keypad. The LED will blink off once to indicate the
keypress acceptance.
5. Display will show the Learn Setup Screen. Press and hold the Setup Key until the
Main Setup Screen is displayed. All Learned Command entries under that Mode are
now cleared.
12 Extra functions:
1. Keypress Acknowledge Beep Feature:
It is possible to get an audible feedback of key-presses. When any key is pressed, the
remote will generate a beep acknowledging the keypress. The Keypress Acknowledge
feature can be toggled on or off as follows:
1. Press and hold Setup key until the LED remains on (this occurs after approximately
2-3 seconds) and the Main Setup Screen is shown.
2. Release Setup key.
3. To disable the beep, press and hold the rubber Stop key until the LED blinks. To
enable the Beep, press and hold the rubber Play key until the LED blinks.
4. Beep Feature now toggled On or Off and the Main Setup Screen is shown.
2. Touchscreen Panel On-Time:
The Touchscreen Panel display will remain on for a User selectable time period (10, 20,
30,...90 seconds). Power-on default is 10 seconds from last keypress. To set the
Touchscreen/Light On time:
1. Press the TV key
2. Press and hold Setup key until the LED remains on (this occurs after approximately 2-3
seconds) and the Main Setup Screen is shown.
3. Release Setup key.
4. Press and release the Setup key. The LED will blink to acknowledge the keypress and
the "9" Digit Setup Screen will be shown.