Marshall electronic V-R653SB-IMD - Manual (Page 23)

23
On-Screen Menu (continued)
IMD CONFIGURATION SUBMENU (continued)
■ IMD ID #
The IMD ID # identifies each screen to the controlling device. When using the TSL protocol, the ID # of each screen
should be manually set in conjunction with the controlling device. When using the Image Video protocol, the ID # may
be set automatically by the controlling device, after each IMD is initially identified by IMD Name (see “IMD Name[S/N]”
below). Available ID #s are 000-255. When using the Marshall protocol, available ID #s are 001-254.
■ IMD Group #
Each screen must be assigned an IMD Group # when using the Marshall protocol. Available Group #s are 01-254.
■ IMD Name (S/N)
Use this setting to assign a name to each screen when using the Image Video or Marshall-IV protocols. The IMD name
is equivalent to the Image Video serial number and is used by the Image Video controlling device to identify
each screen. The default IMD Name(S/N) is “M00001.” It is recommended to maintain this naming scheme in order to
avoid serial number conflicts with other Image Video devices on the same serial bus. Each name can be up to 16
ASCII characters.
Press ENTER to edit the IMD Name. Use the
↑↑↑↑
and
↓↓↓↓
buttons to move the cursor. Press ENTER with the cursor on the
character to be changed and use the
↑↑↑↑
and
↓↓↓↓
buttons to scroll through character options. Press ENTER to choose a
character.
■ IMD Baud Rate
Use this setting to choose the baud rate. The baud rate must be set in conjunction with the controlling device. Available
baud rates are 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200. The TSL v4.0 protocol is fixed at
38400 bauds.
■ IMD Fixed Align
Use this setting to choose the horizontal alignment of the IMD text. IMD text can be justified on the left, center or right
of the screen. This setting is overridden when using IMD text via the Image Video protocol (alignment is set via Image
Video protocol).
■ IMD Fixed Color
Use this setting to choose the color of the IMD Fixed String text (see below). Available colors are red, green, and
yellow. This setting does not affect text color when using IMD text via the Image Video or TSL v4.0 protocols (text
color is set via the protocols).
■ IMD Fixed String
Use this setting to display static IMD text on the screen. This setting is used to enter IMD text locally, when a serial
protocol is not used for remote control. The IMD Fixed String is saved after power cycle. The IMD Fixed String will be
overridden by serial protocol commands.
Press ENTER to edit the IMD Fixed String. Use the
↑↑↑↑
and
↓↓↓↓
buttons to move the cursor. Press ENTER with the cursor
on the character to be changed and use the
↑↑↑↑
and
↓↓↓↓
buttons to scroll through character options. Press ENTER to
choose a character.