Makita 4101RH - Manual (Page 7)

7
12. Use only diamond wheels. NEVER use
tool with wood cutting blades or other
sawblades. Such blades when used on
this tool frequently kick and cause loss of
control leading to personal injury.
13. Check the wheel carefully for cracks or
damage before operation. Replace
cracked or damaged wheel immediately.
14. Use only flanges specified for this tool.
15. Be careful not to damage the spindle,
flanges (especially the installing surface)
or bolt. Damage to these parts could
result in wheel breakage.
16. Make sure the wheel is not contacting the
workpiece before the switch is turned on.
Wait until the wheel attains full speed
before cutting.
17. Stop operation immediately if you notice
anything abnormal.
18. Never attempt to cut with the tool held
upside down in a vise. This can lead to
serious accidents, because it is extremely
dangerous.
19. Do not stop the wheel by lateral pressure
on the disc.
20. Some material contains chemicals which
may be toxic. Take caution to prevent dust
inhalation and skin contact. Follow mate-
rial supplier safety data.
21. If the plug or receptacle does get wet, DO
NOT unplug the cord. Disconnect the fuse
or circuit breaker that supplies power to
the tool. Then unplug and examine for
presence of water in the receptacle.
22. WARNING: To reduce the risk of electro-
cution when using an extension cord,
keep ALL connections dry and off the
ground.
23. Ground Fault Circuit Interrupter (GFCI)
protection should be provided on the cir-
cuit(s) or outlet(s) to be used for the tool.
Receptacles are available having built-in
GFCI protection and may be used for this
measure of safety.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.