Mark Levinson N432 N431 - Manual (Page 19)

19
9. ~ac mains connector
Provides power to the Nº432/431 through the supplied power
cord when the supplied power cord is connected to the ~ac
mains connector
and the electrical outlet. One IEC-standard
AC mains receptacle labeled ~ac mains is available.
Note
Before operating the Nº432/431, make sure the ~ac mains
connector label indicates the correct operating voltage for the
current location.
Warning!
The Nº432/431 has been safety-tested and designed for
operation with a three-conductor power cord. Do not defeat the
“third pin” or “earth ground” of the power cord.
The Nº432/431 includes internal fuses as a final stage of
protection. The protection circuitry is designed so that only a
catastrophic failure will cause these fuses to blow. If this
occurs, disconnect the power cord from the Nº432/431 ~ac
mains connector
and the electrical outlet. Then, contact an
authorized Mark Levinson dealer for assistance. Do not
attempt to replace the fuse. There are no user-serviceable
parts within the Nº432/431.
Danger!
Potentially dangerous voltages and current capabilities exist
within the Nº432/431, even when power is disconnected from
the ~ac mains connector. DO NOT attempt to open the amplifier’s
cabinet. There are no user-serviceable parts inside the amplifier.
Refer all servicing to an authorized Mark Levinson dealer.