Installing or removing socket, Hook, Installing and removing hook – Makita TW0200 User Manual

Page 7

Text mode
Original mode

Installing or removing socket

CAUTION:

•

Always be sure that the tool is switched off and
unplugged before installing or removing the socket.

Align the hole in the side of the socket with the detent pin on
the anvil and push it onto the anvil of the tool until it locks into
place. Tap it lightly if required.
To remove the socket, simply pull it off.

Hook

The hook is convenient for temporarily hanging the tool. This
can be removed without using a tool.This can be installed on
either side of the tool.

Installing and removing hook

Expand the upper part of the hook in both directions and
remove it. To install the hook, follow the removal procedure
in reverse.

1. Socket

2. Anvil

003998

1. Hook

004000