Assembly, Install depth stake as sem bly (see fig. 3), 5unpack carton & install handle (see fig. 2) – McCulloch 96083000400 User Manual
Page 5: Handle height, Tilling width, Tine operation
5
UNPACK CARTON & INSTALL HANDLE
(See Fig. 2)
CAUTION: Be careful of exposed
sta ples when handling or disposing
of cartoning material.
IMPORTANT:
WHEN UNPACKING AND AS SEM BLING
TILLER, BE CAREFUL NOT TO STRETCH OR KINK
CABLE(S).
• Cut cable ties securing handle column.
•. Route cable(s) as shown and slide handle column onto
handle mount.
• Remove all packing from carton.
•
Secure handle column using two (2) carriage bolts and
two (2) flange locknuts. Tighten se cure ly.
• Cut away carton.
• Route tine control cable(s) through plas tic cable clip
on handle mount.
NOTE: Cables must not touch the muffler.
•
Cut cable ties securing tiller to skid. Re move tiller from
skid by pulling backwards.
• Remove screws securing depth stake to skid and
discard the screws.
dep
th_st
ak
e_4
DEPTH
STAKE
SUPPORT
BOLT
HEX BOLTS,
LOCK WASH ERS,
AND HEX NUTS
DEPTH STAKE
SUPPORT
NUT “A”
ENGINE BRACK ET
HALVES
Fig. 3
STAKE
SPRING
ASSEMBLY
HANDLE HEIGHT
•
Handle height may be adjusted to better suit operator.
(See “HANDLE HEIGHT” in the Service and Ad just -
ments section of this manual).
TILLING WIDTH
• Tilling width may be adjusted to better handle your
tilling con di tions (See “TINE ARRANGEMENT” in the
Service and Adjustments section of this manual).
TINE OPERATION
•
Check tine operation before first use. (See “TINE OP-
ERATION CHECK” in the Service and Adjustments
section of this manual).
INSTALL DEPTH STAKE AS SEM BLY
(See Fig. 3)
• Loosen nut “A”.
• Insert stake support between engine brack et halves
with stake spring down.
• Bolt stake support to engine brackets with bolts, lock
washers and nuts. Tight en se curely. Tighten nut “A”.
• Depth stake must move freely. If it does not, loosen
support bolt.
Fig. 2
TILLER
HANDLES
CABLE(S)
HANDLE
PANEL
BOLTS