Miele W 1119 - Manual (Page 25)

Cleaning the water inlet filters
The waher has two water inlet filters to
protect each inlet valve.
These filters should be checked and
cleaned if necessry every 6 months.
This may have to be done more
frequently with some water supplies.
^ Turn off the water valve.
^ Unscrew the inlet hose from the valve
by turning he connector
counterclockwise using a wrench if
necessary.
^ Remove the rubber seal
1 from the
connector.
^ Using needle nose pliers, grasp the
plastic filter, 2 , and pull it out of the
hose connector.
^ Clean the filter under running water
and carefully remove any large
particles.
^ Replace the filter and seal and
reconnect the hose.
Slowly turn on the valve and check for
leaks. If water leaks, tighten the bolt.
Both filters have to be put back in
place after cleaning.
Washer care
25