Metz 28 CS-2 - Manual (Page 25)

- The slave mode set on the slave flash unit is not
suitable for your camera. Select a different slave
mode!
• Yes:
- Check the flash parameters set on the slave flash
unit!
Adapt the unit’s flash parameters to the camera
settings!
Set a positive correction value.
Problem:
All shots are overexposed.
Check the flash parameters set on the slave flash
unit!
Adapt the unit’s flash parameters to the camera
settings!
Set a negative correction value.
Unsuccessful troubleshooting
Turn off the flash unit by the main switch, wait for
a brief moment and then switch the unit on again.
If, in spite of all hints, the flash unit still does not
work, then please consult your local authorized
dealer.
109
ķ
703 47 0165.A1 Inh. 03.08.2004 7:38 Uhr Seite 109