Magnadyne M9800 - Manual (Page 5)

Installation Procedure
Speaker Connections:
Note: Every speaker has a positive (+)
and a negative (-) connection termi-
nal, therefore every speaker must
have two wires connected to it. To
properly connect the speaker system
to your new Magnadyne radio, you
must have a + and - wire coming from
every speaker to connect to the unit.
If you are connecting 2 speakers, you
should have 4 wires to connect. If you
are connecting 4 speakers, you
should have 8 wires to connect.
Wiring Four Speakers:
(Fader Control Operational)
Green Wire:
Connect the Green wire to the Left
Front speaker “Positive” wire.
Green/Black Wire:
Connect the Green/Black wire to the
Left Front speaker “Negative” wire.
Green/Red Wire:
Connect the Green/Red wire to the
Left Rear speaker “Positive” wire.
Black/Green Wire:
Connect the Black/Green wire to the
Left Rear speaker “Negative” wire.
Gray Wire:
Connect the Gray wire to Right
Front speaker “Positive” wire.
Gray/Black Wire:
Connect the Gray/Black wire to the
Right Front speaker “Negative” wire.
Gray/Red Wire:
Connect the Gray/Red wire to the
Right Rear speaker “Positive” wire.
Black/Gray Wire:
Connect the Black/Gray wire to the
Right Rear speaker “Negative” wire.
Wiring Two Speakers:
Green Wire:
Connect the Green wire to the Left
speaker “Positive” wire.
Black/Green Wire:
Connect the Black/Green wire to
the Left speaker “Negative” wire.
Gray Wire:
Connect the Gray wire to the Right
speaker “Positive” wire.
Black/Gray Wire:
Connect the Black/Gray wire to the
Right speaker “Negative” wire.
Warning !
1. Do Not Ground any speakers to the
frame of the vehicle or to any
other grounding system other than
the wires provided in the harness.
2. When the 2 speaker wiring is fol-
lowed, the fader control of the unit
is non-functional
5