Before you call for service, Questions? use this problem solver – GE Monogram ZBD5700 User Manual
Page 22
![background image](/manuals/113716/22/background.png)
22
Before You Call For Service
Dishwasher
Questions?
Use this
problem
solver
PROBLEM
POSSIBLE CAUSE
WHAT TO DO
Dishwasher won’t start
Door not properly closed •Press door until it clicks shut.
Power supply not
•
Check dishwasher is plugged in and
connected.
switch is on.
Child Lockout mode is
•
Press and hold desired button for two
selected
seconds. See Child Lockout mode section
for models ZBD5700 and ZBD5900.
Door opened during
•
Relatch door. Wait a few minutes,
cycle when water is hot
dishwasher will restart automatically.
Timer not set to start of
•
Turn to Cycle Selection starting position
wash cycle
and Option dial to desired position.
Dishwasher is paused
•
To restart the wash, press the selected
wash button.
Door not properly closed
•
Press door until it clicks shut.
Flashing SUPER WASH
Inlet water temperature
•
Reduce hot water inlet temperature to
light (on models
is greater than 175°F.
below 150°F.
ZBD5700 and ZBD5900)
Motor starts but water
Water supply valve
•
Check water supply valve.
doesn’t enter dishwasher
turned off
(Flashing FAST WASH)
(on models ZBD5700
and ZBD5900)
Low inlet water
•
Allow time to heat water (up to one hour).
temperature
•
Check inlet water temperature.
•
Connect to hot water supply.
Water does not empty
Outlet blocked
•
Check outlet hose for kinks and sharp
out of dishwasher
bends.
(Flashing RINSE light)
•Check and clean the drain pump filter.
(on models ZBD5700
and ZBD5900)
•
Check sink trap, garbage disposal and air
gap for blockage.
Dishwasher continues to
Incorrect fill level or
•
Check fill level. See Water Fill Level
drain (Flashing temp
fill time
section.
light) (on models
•Call for service.
ZBD5700 and ZBD5900)
Yellow color on dishes
Water has iron or other
•
A special filter in the water supply line
and glassware
mineral content
is the only way to correct this problem.
Contact a water softener company.
All Cycle Status
Indicators flashing
or beeping every 30
seconds (on models
ZBD5700 and ZBD5900)
Program taking too
long or not advancing
properly (Flashing
NORMAL WASH light)
(on models ZBD5700
and ZBD5900)