GIGABYTE GZ-FSCA1-AN - Manual (Page 14)

14
English
4-8 Installation of Built-in HDD (Hard Disc Drive)
The 3D AURORA provides built-in bays to accommodate up to 5 hard disc drives (after removal of
the tool enclosure). The built-in HDD requires securing runners, which can be found in the black
tool enclosure.
Required tool: Securing runners x 10 in the tool enclosure and power extension cables x 2.
4-7-3 Refer to the installation order illustrated in the left
figure and secure the 3.5” floppy disc drive by
controlling the latch. (reverse steps for disassembly)
4-7-4 Installation completed.
4-8-1 Use the runners installed on both sides of the HDD
evenly and slide the HDD into the hard disk drive
bay.
4-8-2 For installation of the fourth and fifth HDDs, loosen
the tool enclosure, and then install the HDD in
accordance with Step 4-8-1.
4-8-3 In case the length of power cable is not sufficient for
installation of the bottom HDD, it is possible to use
the power extension cable inside the tool enclosure,
depending on the HDD with 4-pin or SATA power
cable.