beautypg.com

Using the parallel fence guide, Dust extraction, Changing the blade – Global Machinery Company MX1275 User Manual

Page 10

background image

Using the parallel fence guide

The parallel fence allows you to make parallel cuts in a

sheet of wood, all at the same width.

Caution.

Always ensure that the saw is switched off and

unplugged from the power supply before making any

adjustments.
1. Slide the parallel fence (9) through the slots in the

base plate.

2. Adjust the guide to the required width and secure it in

position with the locking knob (8).

3. Ensure that the guide rests against the wood along its

entire length to give a consistent parallel cut.

Dust extraction

You can connect the tool to a vacuum system via the dust

extraction port (14).

Changing the blade

Caution.

Always ensure that the saw is switched off and

unplugged from the power supply before making any

adjustments.
1. Rotate the saw blade by

hand whilst depressing the

spindle lock button (17)

until the blade locks.

2. Turn the blade bolt anti-clockwise using the hex key

(20) provided.

3. Remove the outer blade flange and the blade bolt.
4. Retract the lower blade guard (11) using

the lever (10).
5. Remove the saw blade from

the inner flange and pull it out.
6. Clean the saw blade flanges

thoroughly before mounting the

new saw blade.
7. Mount the new saw blade in

reverse order and tighten the

blade bolt.

Warning.

The direction in

which the blade rotates has to be the same as the

direction of the arrow marked on the housing.
8. Ensure that the spindle lock button (17) is released.
9. Before using the saw again, check that the safety

devices are in good working order.

Important.

After replacing the saw blade, make sure that

the saw blade runs freely by turning the blade by hand.

WARNING:

Plug the machine in to a power socket and

run the saw under no load to check that it runs smoothly

before using it to cut any material.

10