About the dryer control panel – GE DBVH510 User Manual
Page 8
8
Operating Instructions
Safety Instructions
Consumer Support
Tr
oubleshooting T
ips
About the dryer control panel.
Dry Temp
You can change the temperature of your dry cycle.
ANTI-BACTERIAL
This option may only be used with COTTONS or MIXED LOAD cycles. This option reduces certain
(on some models)
types of bacteria by 99.9%, including: Staphylococcus aureus, Pseudomonas aeruginosa and Klebsiella
pneumoniae*. The anti-bacterial process occurs when high heat is used during a portion of this
drying cycle.
NOTE: Do not use this cycle on delicate fabrics.
* The Anti-Bacterial Cycle is Certified by NSF International (formerly National Sanitation Foundation)
to NSF Protocol P154 Sanitization Performance of Residential Clothes Dryers.
HIGH
For regular to heavy cottons.
MEDIUM
For synthetics, blends and items labeled permanent press.
LOW
For delicates, synthetics and items labeled Tumble Dry Low.
EXTRA LOW
For lingerie and special-care fabrics.
NO HEAT
Can only be used with TIMED DRY.
(on some models)
START
Press to start a dry cycle. If the dryer is running, press it once and it will pause the dryer.
Press it again to restart the dry cycle.
My Cycle
(on some models)
Set up your favorite combination of settings and save them here for one touch recall.
These custom settings can be set while a cycle is in progress.
To store a MY CYCLE combination of settings:
1. Select your drying cycle.
2. Change DRY TEMP and SENSOR DRY LEVEL settings to fit your needs.
3. Select any drying OPTIONS you want.
4. Press and hold the
pad for three seconds to store your selection. A beep will sound
and the pad will light up.
To recall your stored MY CYCLE combination:
Press the MY CYCLE button before drying a load.
To change your stored MY CYCLE combination:
Follow steps 1–4 in “To store a MY CYCLE combination of settings”.
“CLEAN LINT FILTER” (message)
(This message represents only a reminder.)
After the POWER button is pressed, the “CLEAN LINT FILTER” message could appear if the previous
cycle was not finished.
This message will disappear after the START button is pressed.
Even though you have already cleaned the filter (before or after the POWER button has been
pressed), the “CLEAN LINT FILTER” message will still be displayed until the START button is activated.
MY CYCLE
5
6
7