GE DBVH510 - Manual (Page 12)

12
Operating Instructions
Safety Instructions
Consumer Support
Tr
oubleshooting T
ips
Reversing the door swing.
STEP-BY-STEP INSTRUCTIONS (cont.)
Remove Door Assembly
2. Open the door to approximately 90 degrees. Remove the 4 screws starting
from the bottom to the top. Make sure the door is supported while
removing the screws.
3. Loosen the top screw as shown. Unhook the door by lifting and pulling as
shown by the arrows.
4. Lay the door down on a soft protected flat surface so that the inner part
faces upward (door resting on the handle side).
5. Remove the 6 large tapping screws (#10) located around the perimeter
of the door outlining the gasket, and the 2 machine screws (#8) on the
hinge side.
6. With the screws removed, turn the door over and separate the silver cover
part of the door from the door frame and set aside.
7. Unlock the 4 tabs on the plastic cover and separate the plastic cover from
the frame.
NOTE: Disregard the “DO NOT REMOVE” label on the plastic cover.
6 #10
Large
Screws
2 #8
Machine
Screws
2 #8 Machine Screws
Remove the
four screws