GIGABYTE GIGAFAST GE 2000-N - Manual (Page 18)

ifconfig mtu
eg: ifconfig eth0 mtu 3000
The BUF_SIZE_MAX value in nsm.h (Tunable parameter) should be changed to
4096.
can be increased upto 4000 bytes for sane operation.
Aftermath
Once you have successfully installed the GE 2000-N NIC you can now try to browse the internet
by having an Ethernet cable connected to the NIC (computer) to your internet service provider
(modem). Some people might have trouble connecting to the internet right after the installation
of the card. That is because the computer requires a reboot or the user might need to
disconnect the power off the modem for few minutes so the ISP can do a refresh on the user’s
account. Again, the FAQ guide explains some of the most commonly asked questions. Please
take advantage of our guide and if you need further assistance, please contact our tech support
line or write us an e-mail regard the problem.
Technical Support E-Mail: [email protected]
Technical Support Number: 1(888)-443-6788
Thank you for choosing GigaFast
18