Garmin GMR 404 User Manual
Page 13

GMR 404/406 Owner’s Manual
b
AsIc
o
PerAtIon
>
r
AdAr
P
Age
VRM/EBL
The (Variable Range Marker (VRM) and Electronic Bearing Line
(EBL) tools measure range and bearing to a target. You can move
the center point of the VRM, which allows you to measure from one
target to another. Two
VRM/EBL tools can be active at the same time.
The VRM/EBL option has two areas, VRM/EBL 1 and VRM/EBL 2.
Each area has two settings, Show (Hide) and Adjust.
Varable Range Marker(VRM)
Electronc Bearng Lne (EBL)
To start VRM/EBL 1 or VRM/EBL 2:
On the Radar Adjustment menu, highlight Show
VRM/EBL 1
or
VRM/EBL 2, and then press ENTER.
You can adjust the diameter of the VRM and the angle of the EBL.
To adjust the VRM/EBL:
1. Highlight
Adjust and press the ROCKER to the right. Highlight
Adjust and press ENTER.
2. Press right or left on the
ROCKER to rotate the EBL around
the center point of the VRM.
3. Press up or down on the
ROCKER to increase or decrease
the size of the VMR.
4. Press
ENTER to accept the changes.
To move the center location of the VRM:
1. Highlight
Move, and press ENTER.
2. Using the
ROCKER, move the center point of the VRM to the
selected location.
3. Press
ENTER to set the new location.
To use the VRM/EBL, expand the diameter of the VRM so that the
outer edge touches the target. Rotate the EBL until it intersects the
VRM at the target location. The measured range and bearing are
displayed in the lower-left corner of the screen.